Comments for HHO Fuel

Comment on Catalysts by bill moore

bill moore — Fri, 30 Oct 2009 22:45:30 +0000

please send me any web site containing titanium info.

Comment on Catalysts by Nitin

Nitin — Thu, 29 Oct 2009 08:03:22 +0000

What is the website of the supplier ?

Comment on Featured HFE Cell Type by j madigan

j madigan — Thu, 29 Oct 2009 03:09:39 +0000

interested in the no chemical HHo unit please advise

Comment on Catalysts by Jim

Jim — Wed, 14 Oct 2009 22:23:51 +0000

what is the website?

Comment on Catalysts by Mel Green

Mel Green — Tue, 06 Oct 2009 11:30:47 +0000

Check out the site safehho.com for latest on generators.

Comment on Catalysts by andie

andie — Tue, 06 Oct 2009 01:42:07 +0000

pls information the latest of hho like material and catalyst, i just know abaout this and try to make it for my car.thanks

Comment on Catalysts by Mel Green

Mel Green — Mon, 05 Oct 2009 11:23:00 +0000

KOH has to be the best catalyst and Titanium with multi metal oxide, that I provide, is proven the best next generation generator.

Comment on Catalysts by Mike R

Mike R — Sat, 03 Oct 2009 03:48:47 +0000

found a kit that uses titanium with MMO to improve the production, stop the brown water and only add water once in a while. Kit only cost $400.

Contact me and I will give the web site.
>>>>>>>>>
Hi Mel, what is the website? How much better is it compared to 316L stainless?
Thanks, Mike

Comment on Measuring plate area by Jacques Doyen

Jacques Doyen — Fri, 02 Oct 2009 12:16:20 +0000

Where can I find
drawings
parts list
specifications
I want to make a HHO cell and I think your site will help me.
Thank you for your help
Jack

Comment on Neutral plate test by JaK

JaK — Sun, 30 Aug 2009 05:37:38 +0000

Ok, so far I have been taking in all this info from numerous sources and drawing up design concepts. I am preparing to make my first prototype.

My design idea basically incorporates the same principle as the fluid dynamics of an under-gravel fish tank filter system in order to cool off the electrolyte and thus cooling the entire unit.

Using stainless steel cups with the majority of the bottoms machined out except for some mounting tabs, stack them spaced appropriately narrow tapered side up creating a sort of venturi effect. As the gas is produced and rises the electrolyte naturally begins to flow with it, using this to our advantage we route this up out the top of our housing to a larger sealed system reservoir. The reservoir has a return pipe/hose that exits the reservoir’s bottom and leads to the bottom of our housing allowing the cooler fluid to enter the housing. The HHO is harvested from the top of the reservoir. This obviously won’t create massive flow, but I don’t think we need tons of flow to accomplish the cooling. If it gets hot enough we could possibly route it through a little aux transmission cooler but I doubt that will be neccessary.

But I am trying to plan out the arrangement of the cups/plates. I have 12 condiment cup atm and was hoping to gain some insight on the matter.

I was thinking of from top to bottom doing (-nn+nn-nn+n-)

Since the feedback so far on +n- seems to indicate higher output by comparison having that at the base of my element with 2 nuetral plates in the sequence after (-nn+) the extra little production there would promote flow (give it a little kick start if you will). But I am unsure if this idea will effect the rest of the element in a negative way since it would be setup differently? Does that make sense?