Cell types vary greatly, and I’m not sure yet of the names of all the styles. As posts are made, giving descriptions and details, sub categories will be added for the distinct types.
Cell Types
Posted on June 27, 2008 by daveand5
« Catalysts Containers »
What about using tubular cells like Stanley Meyer’s I’m making a magnetic wound High Voltage AC powered cell assembly using an ever number of tubes wound on the outside polarity matching cell alternating cell polarity +-+- etc. wiring center to outside etc. at 15000VAC for winding and cell power low currant maube 30MA to 100MA.power from inverter to neon transformer.
Additional comment,
Using magnetic force to stretch the covalant bond near its limit should decrease capacitor dialetic strength thus causing more hho release from High Voltage to charge capacitor beyond water’s ability to stay water
What about using tubular cells like Stanley Meyer’s I’m making a magnetic wound High Voltage AC powered cell assembly using an ever number of tubes wound on the outside polarity matching cell alternating cell polarity +-+- etc. wiring center to outside etc. at 15000VAC for winding and cell power low currant maube 30MA to 100MA.power from inverter to neon transformer.
Using magnetic force to stretch the covalant bond near its limit should decrease capacitor dialetic strength thus causing more hho release from High Voltage to charge capacitor beyond water’s ability to stay water
interesting, got pics, schematics? data?
I recently tried winding a wire cell, 5 layers, 1/4″ spacing, wrapped so + fed from top and ended at bottom, – fed from bottom ending at top, similar to that swiss guys spiral wrapped 1/8″ wire cell. Each successive winding was alternating so if looked at cross section the layers were +-+-+
-+-+-
+-+-+, etc
each winding had 16 wraps, the cell only put out 1/2 liter using 12amps @ 12 v.
next i’m gonna wind all 32 wraps neg, the next layer 32 wraps pos, etc and see what that does.
Dr Michael Kay,
what is the end purpose or use of this HV cell?
I think the end purpose of the HV design is the same as any other design but the applications are limited. It might work for use as a large-scale generator for room heating or boiler heating but it would not work so well for vehicle applications as the power needed to make it work would require the engine to work harder than the benefits it produces. Plus there is the issue of space in the average engine compartment to fit all the equipment needed. Maybe I’m wrong, but that is my understanding of that design.
I have container 8×8″x7″tall. Have 3 cells as -nnnn+nnnn-
any ideas as tohookup plan later add 3 more units as lots of room. Thanks Dick D